Citroen C3: Lighting and visibility / Headlamp beam height adjustment

To avoid causing a nuisance to other road users,
the height of the headlamp beams should be
adjusted according to the load in the vehicle.
0. (Initial adjustment)
Driver only or driver + front passenger
-. Driver + front passenger + rear passengers
1. Driver + front passenger + rear passengers +
load in the boot
-. Driver + front passenger + rear passengers +
load in the boot
2. Driver only + maximum authorised load in
the boot
When the ring is in the "AUTO” position, this
system automatically switches between dipped
and main beam headlamps according to the
lighting and traffic conditions, using a camera
located at the top of the windscreen...
In wintry conditions,
remove snow, ice or
frost present on the windscreen, around
the wiper arms and blades and on the
windscreen seal, before operating the wipers...
Other information:
For safety reasons,
adjustments must
only be made when the vehicle is
stationary.
Before taking to the road and to make the most
of the ergonomic layout of the instruments and
controls, carry out these adjustments in the
following order:
head restraint height...
The compressor can be used, without
injecting sealant, to check and, if necessary,
adjust the tyre pressures.
Remove the valve cap from the tyre and keep
it in a clean place.
Uncoil the pipe stowed under the compressor.
Screw the pipe onto the valve and tighten
firmly...