Citroen C3: Spare wheel / Removing the spare wheel

- Unclip the tool storage box (standard spare
wheel).
- Slacken the central nut.
- Remove the fastening device (nut and bolt).
- Lift the spare wheel towards you from the
rear.
- Take the wheel out of the boot.
If there is no wheel in
the well, the
fastening device (nut and bolt) cannot be
refitted.
The spare wheel is installed in the boot, under
the floor.
Depending on engine, the spare wheel is
a standard wheel or the space-saver type
(BlueHDi)...
Parking the vehicle
Immobilise the vehicle where it does
not obstruct traffic: the ground must be level,
stable and non-slippery.
With a manual gearbox, engage first gear
to lock the wheels, apply the parking brake, unless it is programmed to be in
automatic
mode, and switch off the ignition...
Other information:
Refer to the General recommendations on the
use of driving and manoeuvring aids.
Using sensors located in the bumper, this
system signals the proximity of obstacles
(e.g. pedestrian, vehicle, tree, barrier) present in
their field of detection.
Rear parking sensors
The system is switched on by engaging reverse
gear, which is confirmed by an audible signal...
An incorrectly installed
child seat
compromises the child's safety in the
event of an accident.
Ensure that there is no seat belt or seat belt
buckle under the child seat, as this could
destabilise it.
Remember to fasten the seat belts or the
harness of child seats, keeping the slack
relative to the child's body to a minimum,
even for short journeys...