Citroen C3: Stop & Start / Malfunctions
In the event of a malfunction,
this warning
lamp flashes for a few moments, then
remains on, accompanied by an onscreen
message.
Have the vehicle checked by a CITROËN dealer
or a qualified workshop.
The vehicle stalls in STOP mode
All of the instrument panel warning lamps come
on if there is a fault.
- Switch off the ignition then start the engine
again with the key or the "START/STOP" button.
The Stop & Start system
requires a 12 V
battery of specific technology and
specification.
All work concerning the battery must be
carried out only by a CITROËN dealer or a
qualified workshop.
Main conditions for operation
The driver’s door must be closed.
The driver's seat belt must be fastened.
The state of charge of the battery must be
sufficient...
This system automatically checks the pressures
of the tyres while driving.
It compares the information given by the wheel
speed sensors with reference values, which
must be reinitialised every time the tyre
pressures are adjusted or a wheel changed...
Other information:
Hazard warning lamps
Pressing the red button causes all the
direction indicators to flash.
They can operate with the ignition off.
Automatic operation of hazard warning lamps
When braking in an emergency, depending on
the rate of deceleration, the hazard warning
lamps come on automatically...
Release
Pull the parking brake lever up slightly, press
the release button, then lower the lever fully.
When driving the vehicle, if
this warning
lamp and the STOP warning lamp come
on, accompanied by an audible signal and the
display of a message, this means that the
parking brake is still applied or has not been fully
released...