Citroen C3: Practical information / Energy economy mode
This system manages the duration of use of
certain functions, in order to conserve a sufficient
level of charge in the battery with the ignition off.
After switching off the engine, you can still
use functions such as the audio and telematic
system, the wipers and the dipped beam
headlamps or courtesy lamps, for a combined
duration of approximately 40 minutes.
Switching to this mode
A message appears in the instrument panel
screen indicating that the vehicle has switched to
economy mode and the active functions are put
on standby.
If a telephone call is
being made at this
time, it will be maintained for around 10
minutes with the Bluetooth hands-free system
of your audio system.
Exiting the mode
These functions are automatically reactivated the
next time the vehicle is used.
To restore the use of these functions
immediately, start the engine and let it run:
- For less than 10 minutes, to use the
equipment for approximately 5 minutes.
- For more than 10 minutes, to use the
equipment for approximately 30 minutes.
Let the engine run for the specified duration to
ensure that the battery charge is sufficient.
To recharge the battery, avoid repeatedly or
continuously restarting the engine.
A flat battery prevents
the engine from
starting.
For more information on the 12 V battery,
refer to the corresponding section.
Towing device
Load distribution
Distribute the load in the trailer so that the
heaviest items are as close as possible to the
axle, and the nose weight approaches the
maximum permitted without exceeding it...
As a safety measure and to
avoid
damaging the roof, it is essential to use
the transverse bars approved for the vehicle.
Observe the instructions on fitting and use
contained in the guide supplied with the roof
bars...
Other information:
Access to the fuses
The 2 fuseboxes are located in the lower part of
the dashboard, below the steering wheel.
Unclip the cover by pulling at the top left, then
right.
The 2 fuseboxes are located in the lower part of
the dashboard, in the glove box...
Release
Pull the parking brake lever up slightly, press
the release button, then lower the lever fully.
When driving the vehicle, if
this warning
lamp and the STOP warning lamp come
on, accompanied by an audible signal and the
display of a message, this means that the
parking brake is still applied or has not been fully
released...