Citroen C3: Driving / Reversing camera
Refer to the General recommendations on the
use of driving and manoeuvring aids.
The reversing camera is activated automatically
when reverse gear is engaged.
The image is displayed on the touch screen.
The reversing camera
function may be
supplemented by the parking sensors.
The blue lines 1 indicate the general direction of the vehicle (the
gap corresponds to the width of your vehicle including the mirrors).
The red line 2 represents a distance of about 30 cm beyond the edge of
your vehicle's rear bumper.
The green lines 3 represent distances of about 1 6 and 2 metres beyond
the edge of your vehicle's rear bumper.
The turquoise curves 4 show the maximum turning angle in either
direction.
It is normal to have a part of the number plate showing at the bottom of the
screen.
Opening the tailgate
causes the display to disappear.
Clean the reversing camera
regularly using a soft, dry cloth.
Refer to the General recommendations on the
use of driving and manoeuvring aids.
Using sensors located in the bumper, this
system signals the proximity of obstacles
(e...
Other information:
Inertia reel
The seat belts are equipped with an inertia reel
which allows the strap length to automatically
adjust to your shape. The seat belt returns to its
storage automatically when it is not used.
The inertia reels are fitted with a device which
automatically locks the strap in the event of a
collision, emergency braking or if the vehicle rolls
over. It can be released by pulling the s..
Immobilise the vehicle.
With the engine at idle, turn the key to
position 1.
Remove the key from the ignition switch.
To lock the steering column, turn the steering
wheel until it locks.
To facilitate unlocking of
the steering
column, it is recommended that the
wheels be returned to the straight ahead
position before switching off the engine.
Never switch off the
ignition before t..